Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Troubleshooting SIC reset

SIC reset requires 3-5 minutes. If SIC reset was interrupted (for example by loss of network connectivity), run g_cpconfig sic state to get the SIC state. If the SIC State is:

SIC state

Do this

Trust established

Repeat the SIC reset procedure

Initialized but Trust was not established

  1. Reboot all SGMs.
  2. In SmartDashboard > General Properties > Communication, initialize SIC.
  3. Install the policy.

SIC Cleanup

To resolve other SIC issues, do a SIC cleanup. There are two ways to do a SIC cleanup:

Run:

# asg_blade_config reset_sic -reboot_all <activation_key>

OR

  1. Shutdown all SGMs (but not the SMO) using ccutil in Expert mode.
  2. Shutdown all SGMs (but not the SMO) using ccutil in Expert mode.
  3. Connect to the SMO using a serial console.
  4. Initialize SIC in SmartDashboard > General Properties > Communication.
  5. Install policy on the SMO.
  6. Turn on all SGMs.
 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print