Security Group (asg security_group)

To be part of the Security Gateway, an SGM must belong to the Security Group. SGMs are added to the Security group using the asg security_group command. SGMs in the security group:

• Are selected during the initial installation procedure (after running: #setup)
• Are automatically installed once installation of the first SGM has completed
• Can be changed by using the asg security_group command

Syntax

> asg security_group

Example

> asg security_group

Output

 +--------------------------------------+

 |       Security Group Utility         |

 +------------------------------------- +

 Current Security Group:

 +--------------------------------------+

 | Chassis |  Security Gateway Modules  |

 |--------------------------------------|

 |    1    | 1,2,3                      |

 |--------------------------------------|

 |    2    | 1,2,3                      |

 +--------------------------------------+

 Choose one of the following options:

------------------------------------

 1) Add SGMs to Security Group

 2) Remove SGMs from Security Group

 3) Exit

Notes

Select which SGMs must be added or removed from the security group. Note that:

• An SGM added to the security group automatically joins the Single Management Object of the Security Gateway and then reboots
• Before you remove an SGM from the security gateway, make sure that its state is DOWN.
• To optimize connection distribution amongst the SGMs, keep the security group updated with the actual number of SGMs in the appliance.