Configuring the SD-WAN Device

When you create a branch site in Check Point Harmony Connect, you must configure your branch office to route the traffic through Harmony Connect.

Check Point creates the back-end architecture to tunnel the traffic from the branch device to the internet.

To configure your branch SD-WAN device:

1. Log in to the Check Point Infinity Portal and navigate to Harmony Connect > Assets > Branches & Datacenters.

2. Click Configure branch device from your applicable branch device.

   The Instructions window appears.

3. Select Generic Router / SD-WAN.

4. Copy the tunnel properties with two tunnel destinations and other parameters.

   

5. Click Close.