Adding a New VPN Site to an Exported Package

When you use an exported package, you can configure each package to connect to a default VPN site which you create.

By default, no VPN site is configured for a new package.

To add a new VPN site to an exported package:

  1. Create a package or edit an export package. See Manual Deployment of Endpoint Clients.

  2. In the Capabilities screen of the Create Export Package wizard, select the Remote Access VPN checkbox.

  3. In the Virtual Groups and VPN Sites screen, in the VPN site section:

    1. To add a VPN site manually, select Manual:

      1. Click New and enter these:
        • Name - Unique name for this VPN site.

        • Site Address - Site IP address.

        • Authentication Method - One of these:
          • Username-password - Endpoint users authenticate using their VPN user name and password.

          • CAPI certificate - Endpoint users authenticate using the applicable certificate.

          • P12 certificate - Endpoint users authenticate using the applicable certificate.

          • SecurID KeyFob - Endpoint users authenticate using a KeyFob hard token.

          • SecurID PinPad -Endpoint users authenticate using the an SDTID token file and PIN.

          • Challenge-response - Endpoint users authenticate using an administrator supplied response string in response to the challenge prompt.

      2. Click OK.

    2. To add a VPN site by importing a .config file, select Import from file:

      1. Click Upload and select the .config file you want to upload.

        Note - Only .config file with a maximum file size of 1000 KB is supported.

      2. Click Next and continue with step i in Create an export package. See Manual Deployment of Endpoint Clients.