Getting Started

To integrate Check Point Harmony Connect with Cisco SD-WAN vManage, perform these steps:

  1. Create an Account on the Check Point Infinity Portal. See Creating an Account in the Check Point Infinity Portal.

  2. Create a new site. See Creating a New Site.

  3. Configure IPsec tunnels and routes in Cisco SD-WAN vManage. See Configuring Cisco vManage on the SD-WAN Device.

  4. Monitor end-to-end traffic in Cisco SD-WAN vManage. See Testing your Configuration

  5. Monitor cybersecurity events at the Check Point Infinity Portal. See Monitoring Cybersecurity Events.