- You cannot run the CDT on:
- Security Management Server in Backup state (in Management High Availability)
- Dedicated SmartEvent Server
- Dedicated Log Server
- Multi-Domain Log Server
- Domain Log Server
- Members of Full HA cluster
- You cannot run multiple instances of the CDT at the same time (except when you use the ).
- CDT does not support exported CPUSE packages (with
*.tar
extension).Note - CDT supports only CPUSE Offline packages (with*.tgz
extension).
- CDT does not support Clean Install of a Major version.
Note - This does not apply to the .
- CDT does not support clusters with more than two members.
Note - This does not apply to the VSX Virtual System Load Sharing cluster.
- CDT does not support ClusterXL in Load Sharing modes.
- CDT does not support Security Gateways in VSX mode.
- CDT does not support Scalable Platforms 40000 and 60000.
- CDT does not support ROBO Gateways managed by SmartProvisioning.
- CDT does not support installation of packages that contain RPM files (for example, CPinfo package).
- CDT does not support Security Gateways that run only IPv6 (without IPv4 address configured on the applicable management interface).
- CDT does not support a scheduled job in Gaia OS on your Management Server to collect the RMA backup information.
- If you use the Connectivity Upgrade (CU) in ClusterXL, see the Connectivity Upgrade R77.x and R80.x Versions Best Practices - Chapter Connectivity Upgrade Limitations.
- Hotfix for disabling and removing Kaspersky Lab components (see sk118539):
- CDT does not support installation of this hotfix.
- CDT does not support RMA Backup on computers, on which this hotfix is installed.
- CDT does not support RMA Restore on computers, on which this hotfix was installed.