General Requirements for Racks

Check Point 2U Security Management Appliances are designed for a standard 19-inch (48.26 cm) rack (see specification EIA-310-D). The telescoping rails can be used with racks that have round holes, square holes, or threaded holes. The telescoping rails are designed for racks with these specifications:

Rack Holes	Minimum Depth	Maximum Depth	SKU
Round	617 mm	861 mm	CPAC-RAILS-SM6000-L/XL
Square	631 mm	868 mm
Threaded	631 mm	883 mm

Front and rear rack doors must have equally distributed holes on at least 65% of the surface area to give sufficient airflow. Make sure that the racks have sufficient clearance to service the Check Point Security Management Appliances that are mounted on telescoping rails.

Rack Side	Clearance Requirement
Front	36 in (91.4 cm) plus additional clearance, if necessary, for the mechanical lift used to move the Security Management Appliance and rails equipment.
Rear	16 in (40.6 cm) from the rear of the rack or Security Management Appliance without the rear cabinet door. 22 in (55.9 cm) from the rear of the rack or Security Management Appliance with the rear cabinet door.

Security Management Appliance Physical Specifications

Model	Width	Depth	Height
Smart-1 6000-L Smart-1 6000-XL	434 mm	737.5 mm	86.8 mm (2U)