Safety Warnings

Read all installation instructions before you connect the equipment to the power source.

Use enough people to lift this product safely:

With the fan unit removed, power pins are accessible within the module cavity.

Do not insert tools or body parts into the fan unit cavity.

Do not operate this equipment in an area with an ambient temperature that exceeds the recommended maximum: 45°C (113°F).

To guarantee proper cooling, allow at least 8 cm (3 inches) of clearance around the ventilation openings.

Do not stack the Chassis on any other equipment. If the Chassis falls, it can cause bodily injury and equipment damage.

This product includes a redundant power supply or a blank cover in its place.

In case of an empty power supply bay, do not operate this equipment with the blank cover removed, or not properly fastened.

This Quantum Maestro Orchestrator A scalable Network Security System that connects multiple Check Point Security Appliances into a unified system. Synonyms: Orchestrator, Quantum Maestro Orchestrator, Maestro Hyperscale Orchestrator. Acronym: MHO. has double pole/neutral fusing.

Remove all power cords before you open the cover of this product or touch any internal parts.

The Power Supply Units are all independent.

Disconnect all power supplies to ensure a powered down state inside of this equipment.

During periods of lightning activity, do not work on the equipment, connect or disconnect cables.

Copper cables are heavy and not flexible. Therefore, carefully attach or detach them from the connectors.

Refer to the cable manufacturer for special warnings and instructions.

When this product is mounted or serviced in a rack, you must take special precautions to ensure that the Quantum Maestro Orchestrator See "Maestro Orchestrator". remains stable.

In general, fill the rack with equipment from the bottom to the top.

Only trained and qualified personnel should install, replace, and service this equipment.

Dispose of this equipment in compliance with all national laws and regulations.

Install this equipment according to the latest version of the country national electrical codes.

For North America, see the applicable requirements in the US National Electrical Code and the Canadian Electrical Code.

Warning: Replace only with UL Recognized battery, certified for maximum abnormal charging current not less than 4 mA.

There is a risk of explosion, if you replace the battery with a battery of an incorrect type.

Dispose of used batteries according to the instructions.

For North American power connection, select a power supply cord that is UL Listed and CSA Certified, 3 - conductor [16 AWG], terminated with a molded plug rated at 125 V [13 A], with a minimum length of 1.5 m [6 feet], but no longer than 4.5m (15 feet).

For European connection, select a power supply cord that is internationally harmonized and marked "<HAR>", 3 - conductor, minimum 1.0 square mm wire, rated at 300 V, with a PVC insulated jacket. The cord must have a molded plug rated at 250 V, 10 A.

Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL certified type DP-1 or DP-2 (Note - When residing in non LPS circuit).

You must incorporate in the building wiring a readily accessible listed branch circuit overcurrent protective device rated 20 A.

Caution - Do not use the slide / rail mounted equipment as a shelf or a work space. The rails are not intended for sliding the unit away from the rack. It is for permanent installation at final resting place only, not used for service and maintenance.

According to the WEEE Directive 2002/96/EC, all waste electrical and electronic equipment (EEE) should be collected separately and not disposed of with regular household waste.

Dispose of this product and all of its parts in a responsible and environmentally friendly way.

This unit is intended for connection to a TN power system and an IT power system of Norway only.