Quantum Scalable Chassis Getting Started Guide

Step 4: Turning on and Turning off the Chassis

To turn on the Chassis:

Connect the appliance to the power source.

At power up:

Fan speed goes to maximum.
LEDs on the Chassis Management Module A hardware component that controls and monitors 60000 / 40000 Appliance (Chassis) operation such as, fan speed, Chassis and module temperature, and component hot-swapping. Acronym: CMM. light up.
After 1-60 seconds, fan speed decreases until it reaches the optimum rate for cooling.
Chassis Management Module ACT and PWR LEDs show a green color.
Other LEDs turn off.

To turn off the Chassis:

Step

Instructions

1

Shutdown the SGMs:

If the installation wizard has not run yet, release the levers on each SGM to shut them down.

If the installation wizard has run, then run in Gaia gClish The name of the global command line shell in Check Point Gaia operating system for Security Gateway Modules. Commands you run in this shell apply to all Security Gateway Module in the Security Group.:

asg_hard_shutdown -b all

2

Release the levers on each SSM.

3

Release the levers on each CMM.

4

Wait for the LEDs on SGMs, SSMs, and CMMs (on each Chassis) to show a steady blue color.

5

Unplug the power cords.

22 April 2024

© 2019 Check Point Software Technologies Ltd.