SGM400 Security Gateway Module LEDs
|
Item |
LED |
Status |
Description |
|---|---|---|---|
|
1 |
Out of Service
|
Red |
SGM is out of service. |
|
|
|
Off (Normal) |
SGM hardware works normally. |
|
2 |
Power
|
On (Normal) |
Power on the SGM is on. |
|
|
|
Off |
Power on the SGM is off. |
|
3 |
TRAFFIC
|
On (Normal) |
SGM Data and Sync traffic in the SSM #1 / SSM #2 flow correctly. |
|
|
|
Off |
SGM Data and Sync traffic do not flow in the SSM #1 / SSM #2. |
|
4 |
MGMT
|
L - Orange |
Link from the SGM to the SSM #1 / SSM #2 is on. |
|
|
|
S - Orange blinking |
There is activity in the SSM #1 / SSM #2. |
|
|
|
Off |
Link from the SGM to the SSM #1 / SSM #2 is off. |
|
5 |
USR
|
Lower right LED is lit in red
|
Installation started. |
|
|
|
All LEDs are blinking in red, in sequence
|
Installation in progress. |
|
|
|
All LEDs are lit in red
|
Installation failure. |
|
|
|
Left LEDs are lit in yellow
|
Installation completed. |
|
|
|
Right LEDs are lit in green
|
SGM is being configured (Using the Gaia First Time Configuration Wizard or adding a new SGM into a Chassis). |
|
|
|
All LEDs are off |
SGM is configured and ready. |
|
6 |
Hot-swap status
|
Blue |
SGM can be safely removed. |
|
|
|
Blue blinking |
SGM is going to the Standby mode. Do not remove. |
|
|
|
Off (Normal) |
SGM is in the Active mode. Do not remove. |
