SGM260 Security Gateway Module
|
|
Important - R81.20 and higher versions do not support this SGM model. |
|
Item |
Name |
Description |
|---|---|---|
|
1 |
CTRL, LINK SPEED |
LEDs that show status of link and activity of the management ports on the SSM #1 / SSM #2. |
|
2 |
|
LED that shows the Out of Service status. |
|
3 |
|
LED that shows the Health status. |
|
4 |
A |
Alternative port for direct access through console. |
|
5 |
|
Mini USB port for direct access through console. |
|
6 |
CONSOLE |
1 x RJ45 port for direct access through console. |
|
7 |
|
LED that shows the Hot-swap status of the SGM. |
|
8 |
TRAFFIC |
LEDs that show status of SGM Data and Sync traffic in the SSM #1 / SSM #2. |
|
9 |
TRAFFIC |
LEDs that show status of SGM Data and Sync traffic in the SSM #1 / SSM #2. |
|
10 |
CTRL |
LEDs that show status of link and activity of the management ports on the SSM #1 / SSM #2. |
|
11 |
L2 |
These LEDs are not used. |
|
12 |
L1 |
LEDs that show the installation status on the SGM. |
|
13 |
RESET |
Reset (reboot) button for the SGM. |
|
14 |
|
2 x USB v2.0 ports. Use these ports to connect a bootable USB drive to install a Check Point software ISO image. |
|
15 |
LAN 1 2 3 |
For Check Point internal use only (output of the |
