SGM260 Security Gateway Module LEDs
|
Item |
LED |
Status |
Description |
|---|---|---|---|
|
1 |
CTRL
|
Green |
1 Gbps. |
|
|
|
Yellow |
10 Gbps. |
|
|
|
Off |
100 Mbps. |
|
2 |
TRAFFIC
|
On |
Data and Sync traffic from the SGM flows in the SSM #1, SSM #2, SSM #3, and SSM #4. |
|
3 |
Out of Service
|
Red |
SGM is out of service. |
|
|
|
Off (Normal) |
SGM hardware works normally. |
|
4 |
Health
|
Green (Normal) |
SGM core operating system is Active. |
|
|
|
Green blinking |
SGM core operating system is partially Active. |
|
|
|
Off |
SGM core operating system is in the Standby mode. |
|
5 |
TRAFFIC
|
On |
Data and Sync traffic from the SGM flows in the SSM #1, SSM #2, SSM #3, and SSM #4. |
|
6 |
CTRL
|
Green |
1 Gbps. |
|
|
|
Yellow |
10 Gbps. |
|
|
|
Off |
100 Mbps. |
|
7 |
L2 |
Off |
These LEDs are not used. |
|
8 |
L1
|
Lower right LED is lit in red
|
Installation started on the SGM. |
|
|
|
All LEDs are blinking in red, in sequence
|
Installation in progress on the SGM. |
|
|
|
All LEDs are lit in red
|
Installation failure on the SGM. |
|
|
|
Left LEDs are lit in yellow
|
Installation completed on the SGM. |
|
|
|
Right LEDs are lit in green
|
SGM is being configured (Using the Gaia First Time Configuration Wizard or adding a new SGM into a Chassis). |
|
|
|
All LEDs are off |
SGM is configured and ready. |
|
9 |
Hot-swap status
|
Blue |
SGM can be safely removed. |
|
|
|
Blue blinking |
SGM is going to the Standby mode. Do not remove. |
|
|
|
Off (Normal) |
SGM is in the Active mode. Do not remove. |
