Control Panel for the 64000 and 61000 N+N Chassis

You can use the Control Panel for a serial connection to a specific Chassis Management ModuleClosed A hardware component that controls and monitors 60000 / 40000 Appliance (Chassis) operation such as, fan speed, Chassis and module temperature, and component hot-swapping. Acronym: CMM. (CMM).

It also shows the status of cooling fans and additional Chassis alerts.

This Control Panel is installed only in the 64000 Chassis and 61000 N+N Chassis (see Front Panel on the 64000 Chassis and Front Panel on the 61000 N+N Chassis).

Item

Name on Panel

Description

1

Upper CMM Serial

Serial port for connecting to the upper Chassis Management Module (CMM).

2

Lower CMM Serial

Serial port for connecting to the lower Chassis Management Module (CMM).

3

ALARM

Chassis alarm port - for connecting to customer supplied external device.

4

ALARM CUTOFF

Chassis alarm reset button.

5

Chassis Alerts

Normally off.

If the LEDs are lit in red, the chassis sends system alarm events:

  • CRT - Critical.

  • MJR - Major.

  • MNR - Minor.

For assistance, contact Check Point Support.

6

FAN

Numbers of cooling fans.

7

STATUS

Cooling fans status LEDs:

  • Green - All fan tray components work correctly.

  • Red - Fan tray failure.

  • Off - Fan tray is not installed.

8

FAULT

Normally off.

If the LED is lit, there is a failure in the cooling fan.